bending stress การใช้

• But when alternative bending stress are induced, failure was inevitable.
• For extremely long thermowells, the static component of the bending stresses may govern design.
• In other situations, however, the bending stress of a thin plate cannot be neglected.
• Common elastic moduli are;; and; and common allowable bending stress values are; and.
• The bending stress distribution in a beam does depend on the point of application of the loads.
• This was also due to the unexpected bending stress which progressively squeezed the lubricant out of the gap.
• Bench seat stanchions were moved inboard to reduce bending stress in the seat frames, allowing them to be lighter.
• This is called a " cyclic bending stress " and the aerial lift above is a good example.
• Loaded with only a moment, the peak bending stresses occurs at the outside fibers of a cross-section.
• It may seem counterintuitive at first, but this is because there are no bending stresses in the neutral axis.
• The struts are primarily compression members, but friction at the pin-hub interface induces a bending stress during gate operation.
• That torque is modeled as a "'bending stress "'that tends to change the curvature of the plate.
• This bending stress may be superimposed with axially applied stresses, which will cause a shift in the neutral ( zero stress ) axis.
• For drilled bar-stock thermowells, the most common form of failure is bending fatigue at its base where the bending stresses are greatest.
• Laminated veneer lumber is similar in appearance to plywood without crossbands, and is typically rated by the manufacturer for elastic modulus and allowable bending stress.
• Principal stresses are often expressed in the following equation for evaluating stresses in the x and y directions or axial and bending stresses on a part.
• Using this equation it is possible to calculate the bending stress at any point on the beam cross section regardless of moment orientation or cross-sectional shape.
• Elementary Elastic Bending theory requires that bending stress varies linearly with distance from the neutral axis, but plastic bending shows a more accurate and complex stress distribution.
• While forming the cavity, the laser beam is scanned, a machined surface is formed, and thereafter the work can be cut with a weak bending stress.
• The tool is therefore usually angled so that the movable jaw's area of contact is closer to the body of the tool, which means less bending stress.